{
    "lazyNodes": false,
    "abFitnotesFlag": false,
    "abCrawlReviews": false,
    "productOptionsCookie": false,
    "orderDelayFlag": false,
    "skipSessionCookie": false,
    "covidMessage": false,
    "fullTitleCookie": false,
    "nrLoggerCookie": false,
    "checkoutReviewCookie": false,
    "productOptionSeqCookie": false,
    "maintenanceFlag": false,
    "bufferETACookie": false,
    "multiShippingDiscountFlag": false,
    "newFitmentFlag": false,
    "surveyOptInFlag": false,
    "crossSellFlag": false,
    "skuMappingFlag": false,
    "paySplitCookie": false,
    "callDisableFlag": false,
    "zipPaymentFlag": "u",
    "hassleFreeReturn": false,
    "lifetimeReplacement": false,
    "cpn_off": false
}
Select your vehicle

Volvo S90 Coolant Level Sensors

Refine by:

Shop Catalog

Showing 1 - 1 of 1 results
Sort by:
1712544 Coolant Level Sensor - Direct Fit
Part Number: GPD1712544
Vehicle Info Required to Guarantee Fit
$52.99
Product Details
Warranty : 1 year GPD limited warrantyQuantity Sold : Sold individuallyProp 65 Warning :

Warning SymbolWARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Product Fit : Direct Fit
Page 1 of 1 | Showing 1 - 1 of 1 results

Helpful Automotive Resources

P2181 Code: Cooling System Performance
P2181 Code: Cooling System PerformanceThis code is similar to a P0128 or P0125 code but can also indicate engine overheating or electrical problems with the sensor circuit.
P0507 Code: Idle Control System RPM Higher than Expected
P0507 Code: Idle Control System RPM Higher than ExpectedMaintaining a proper idle speed plays an important role in reducing tailpipe emissions and preventing the engine from stalling.
Bad Coolant Level Sensor Symptoms
Bad Coolant Level Sensor SymptomsOther GM cars might have a sensor with a plastic float that has metal contacts on the bottom side to close a circuit when the coolant level gets low. Usually, the signal is sent to a module or the BCM and a request is sent to the instrument cluster to