{
    "lazyNodes": false,
    "abFitnotesFlag": false,
    "abCrawlReviews": true,
    "productOptionsCookie": false,
    "orderDelayFlag": false,
    "skipSessionCookie": false,
    "covidMessage": false,
    "fullTitleCookie": false,
    "nrLoggerCookie": true,
    "checkoutReviewCookie": false,
    "productOptionSeqCookie": false,
    "maintenanceFlag": false,
    "bufferETACookie": false,
    "multiShippingDiscountFlag": false,
    "newFitmentFlag": false,
    "surveyOptInFlag": true,
    "crossSellFlag": false,
    "skuMappingFlag": false,
    "paySplitCookie": false,
    "callDisableFlag": true,
    "zipPaymentFlag": "c",
    "hassleFreeReturn": true,
    "lifetimeReplacement": true,
    "cpn_off": false
}
Select your vehicle

Omix Blower Motors

Refine by:

Shop Catalog

Showing 1 - 2 of 2 results
Sort by:
17904.02 Blower Motor
Part Number: O321790402
Vehicle Info Required to Guarantee Fit
$79.49
Product Details
Motor Wheel Included : Without Motor WheelProduct Fit : Direct FitQuantity Sold : Sold individuallyWarranty : 5-Year Omix Limited WarrantyProp 65 Warning :

Warning SymbolWARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

17904.03 Blower Motor
Part Number: O321790403
Vehicle Info Required to Guarantee Fit
$144.99
Product Details
Notes : Without blower wheelMotor Wheel Included : Without Motor WheelProduct Fit : Direct FitQuantity Sold : Sold individuallyWarranty : 5-Year Omix Limited WarrantyProp 65 Warning :

Warning SymbolWARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Page 1 of 1 | Showing 1 - 2 of 2 results

Product Questions & Answers

Q:What is the size of the motor that sticks thru the firewall. Just the motor size should be like 3 inches or smaller.  All the parts I buy say 3 inches and that's to big to fit thru the circle in the firewall.  1989 wrangler 4.0l? Show Less
Behr T.
A:BEST ANSWERHi Behr, I'm pleased to assist you. The motor housing diameter is approximately 3.125 inches, this is close to 3 inches, but still slightly larger than the firewall hole. The blower motor shaft diameter is typically around 5/8 inches (0.625 inches), this should fit comfortably through the 3.15-inch firewall hole. Check if there is a way to make it fit. If there is, click the link below to continue ordering today before the sale ends. Happy shopping! https://www.carparts.com/blower-motor/omix/o321790402?can=CPGG4850_CSQA_20240109 Show less
Grace G.
 
2 Questions, 1 AnswerView all Q&As >

Helpful Automotive Resources

Where Is the Blower Motor Resistor Located?
Where Is the Blower Motor Resistor Located?The blower motor resistor of the 2005 Toyota Tacoma is on the firewall to the left of the motor. In the 2008-2011 Ford F-150, the resistor sits behind the glove compartment on the air duct’s right side. This is a photo of the blower resistor as it is mounted in the
Heating System Parts
Heating System PartsOur Top Picks Replacement REPC503005 Heater Core 4-Seasons 98466 Heater Core GPD 8231379 Heater Core – Front, Aluminum Core One Stop Solutions 98010 Heater Core AC Delco 15-63728 GM Original Equipment Series Heater Core Blower Motor
Tips for Changing a Blower Motor
Tips for Changing a Blower MotorWhen you adjust your vehicle’s A/C, the blower motor speed changes according to your settings. On older vehicles, a switch and resistor assembly controls the blower motor speed, while in newer vehicles, the blower motor receives instructions from a module connected to the HVAC control unit.