Watch this video to learn how to replace the turn signal switch on a 2009-2018 Dodge RAM 1500.
Ready to perform this DIY job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.
Here’s the toolbox we recommend to repair your Dodge RAM 1500: HM85 85 Piece Ratchet and Socket Set
List of tools:
Step 1: Turn your engine off and set the parking brake.
Step 2: Using a Torx T20 screwdriver, loosen the two screws holding the plastic trim of the steering column.
Step 3: Using a plastic fork, pry the upper plastic trim so that you can remove it.
Step 4: Disconnect the electrical connector from the turn signal switch by pressing the plastic tab.
Step 5: You can now remove the turn signal switch by pressing the locking tab and pulling it upwards.
Step 6: Take the new turn switch signal. Put it back in its place. Then reconnect it.
Step 7: Put the upper plastic trim back in place. Then screw the 2 retaining screws back in.
Step 8: You can now test your turn signal switch.
The operation and tools displayed in the video should be available on the following vehicles:
Disclaimer:
This video is for entertainment purposes only. CarParts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.