Watch this video to learn how to replace the rear bumper on a 2009-2014 Ford F-150.
Replacing Rear Bumper on a 2009-2014 Ford F-150: What You Need
Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.
Parts Checklist
Tightening Torques
There are no tightening torques for this operation.
Tools Checklist
Here’s the toolbox we recommend to repair your Ford F-150: HM85 85 Piece Ratchet and Socket Set
List of tools:
- Thin flat head screwdriver
- Ratchet
- 21mm socket
Step-by-Step Instructions
Step 1: Turn off your engine and engage the parking brake.
Step 2: Use a thin flathead screwdriver to carefully remove the first license plate lightbulb holder from the rear bumper.
Step 3: Turn the holder counterclockwise to disengage it from the bulb. Gently pull the bulb out to remove it.
Step 4: Slide the connector of the bulb through the opening in the rear bumper. Repeat the same process for the second license plate lightbulb.
Step 5: Position yourself under the vehicle. Proceed to unscrew the nuts holding the rear bumper. Depending on the version, there may be four or six nuts.
Step 6: Use a ratchet and a 21-mm socket to unscrew the two nuts located near the leaf spring attachments. Remove them.
Step 7: Before unscrewing the nuts on the other side, make sure someone holds the rear bumper to prevent it from falling. Then, unscrew the remaining two mounting nuts.
Step 8: Carefully remove the old rear bumper. Insert the mounting screws of the new rear bumper into their respective slots.
Step 9: While tightening the screws, have someone assist you in holding the rear bumper to avoid any damage.
Step 10: Begin by screwing the nuts back on finger-tight to hold the assembly together. Utilize the oblong holes in the supports to adjust the rear bumper’s height.
Step 11: Once the bumper is properly positioned and horizontally aligned, use the ratchet to finish tightening the nuts securely.
Step 12: Pass the connector of the first license plate lightbulb through the opening in the rear bumper.
Step 13: Reinsert the bulb into its base. Twist the holder clockwise to secure it. Place the holder back into the rear bumper. Repeat the same process for the second license plate lightbulb.
Compatible Vehicles
The operation and tools displayed in the video should be available on the following vehicles:
Important Reminders
Before unscrewing the nuts on the other side, make sure someone is holding the rear bumper to prevent it from falling.
You can adjust the height of the rear bumper thanks to the oblong holes in the supports.
Disclaimer:
This video is for entertainment purposes only. Carparts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.
