How to Replace Spark Plugs: 2009-2014 Ford F-150

Watch this video to learn how to replace spark plugs on a 2009-2014 Ford F-150.

Replacing Spark Plugs on a 2009-2014 Ford F-150: What You Need

Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.

Parts Checklist

• Spark Plugs

Tightening Torques

• Spark plugs : 11 Ft-lbs
• Coil retaining bolt : 5 Ft-lbs

Tools Checklist

Here’s the toolbox we recommend to repair your Ford F-150: HM85 85 Piece Ratchet and Socket Set

List of tools:

• Ratchet
• Extender
• 7mm socket
• Plastic tube
• Vacuum cleaner
• Long extender
• 14mm spark plug socket
• Torque wrench
• Torque wrench angle gauge

Step-by-Step Instructions

Step 1: Turn off the vehicle’s ignition, engage the parking brake, and open the hood.

Step 2: Locate the spark plugs in the engine compartment.

Step 3: For better access, disconnect the fuel injector by pressing the tab and pulling the connector.

Step 4: Disconnect the power from the ignition coil by pressing the tab and pulling the connector.

Step 5: Use a socket wrench, extender, and 7 mm socket to remove the holding screw from the ignition coil.

Step 6: Carefully remove the coil with small back and forward movements.

Step 7: To prevent debris from falling into the engine, use a thin plastic tube attached to a vacuum to clean around the spark plug.

Step 8: Use a socket wrench, extender, and 14mm spark plug socket to loosen and remove the spark plug. Finish unscrewing by hand and remove the plug.

Step 9: Take the new spark plug and insert it into the spark plug socket. Gently align it with the screwing support.

Step 10: Hand-tighten the new spark plug, then secure it in place with a socket wrench.

Step 11: Choose a technique for tightening the spark plug:

• Use a torque wrench with the manufacturer’s recommended tightening torque.
• Use an angular torque gauge to match the recommended angle.

Step 12: Push the ignition coil back in as far as possible and secure the nut using a socket wrench. Finish tightening with a torque wrench.

Step 13: Reconnect the ignition coil by attaching the connector.

Step 14: Reconnect the fuel injector by pressing the connector into place.

Step 15: Repeat the process for the other spark plugs.

Note: Make sure to follow the manufacturer’s recommendations for tightening torque or angle.

Compatible Vehicles

The operation and tools displayed in the video should be available on the following vehicles :

• 2009 Ford F150
• 2010 Ford F150
• 2011 Ford F150
• 2012 Ford F150
• 2013 Ford F150
• 2014 Ford F150

Important Reminders

We advise replacing the spark plugs one by one since it is crucial not to get the coils mixed up.

Be careful as these coils are fragile. Handle it with care.

Disclaimer:

This video is for entertainment purposes only. CarParts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.