Watch this video to learn how to replace side view mirror on a 2009-2014 Ford F-150.
Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.
There are no tightening torques for this operation.
Here’s the toolbox we recommend to repair your Ford F-150: HM85 85 Piece Ratchet and Socket Set
List of tools:
Step 1: Turn off the engine and engage the parking brake. Open the car door.
Step 2: To change the side view mirror, start by removing the door trim.
Step 3: Use a flathead screwdriver to remove the plastic cover inside the door handle.
Step 4: With a multi-bit screwdriver and an 8mm bit, unscrew the screw holding the inner door panel.
Step 5: Use a 6mm socket to unscrew the two screws located at the bottom of the inner door panel.
Step 6: Gently remove the inner lining of the door opener using a fork.
Step 7: Unscrew the final screw holding the door panel using an 8mm socket.
Step 8: Lift off the door panel from the top track and place it on a raised surface to avoid damaging cables. This grants access to the three retaining nuts of the side view mirror.
Step 9: Use a ratchet and an 11mm socket to unscrew the three holding screws on the side view mirror.
Step 10: Slightly pull out the mirror to disconnect the electrical connection by pushing on the holding pin.
Step 11: Remove the old side view mirror and prepare the new one.
Step 12: Take off the rubber protectors from the new mirror and plug the electrical connector back in.
Step 13: Insert the new side view mirror into its housing and hand-tighten the three nuts. Finish tightening the nuts using a ratchet.
Step 14: Before reinstalling the door panel, identify the retaining hooks that need to fit into the door structure.
Step 15: Carefully place the door panel back on, ensuring the entire trim rests against the door.
Step 16: Pass the door lock latch through the trim and ensure the trim is correctly aligned.
Step 17: Once the panel is properly positioned, screw in the screw that lines up with the door’s opening system.
Step 18: Put the inner lining back in place and screw back the screw located in the handle.
Step 19: Replace the plastic cover and secure the two screws located at the bottom of the inner door panel.
The operation and tools displayed in the video should be available on the following vehicles :
To change your car’s side view mirror, you have to take off the door trim.
Disclaimer:
This video is for entertainment purposes only. CarParts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.