Watch this video to learn how to replace front brake hose on a 2009-2014 Ford F-150.
Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.
There are no tightening torques for this operation.
Here’s the toolbox we recommend to repair your Ford F-150: HM85 85 Piece Ratchet and Socket Set
List of tools:
Step 1: Turn off the engine, set the parking brake, pull the hood release handle, and open the hood.
Step 2: Open the brake fluid reservoir.
Step 3: Loosen the stud bolts on the front wheels.
Step 4: Lift the front of your vehicle and securely place it on axle stands. Watch our “How to jack your Ford F-150 safely” video for guidance before proceeding.
Step 5: To change brake hoses, remove the wheel for access. Place the wheels under the vehicle.
Step 6: Turn the disk inward for easier access, then disconnect the ABS sensor cable from the brake hose.
Step 7: Use a ratchet and a 10mm socket to unscrew the brake hose clamp from the wheel knuckle.
Step 8: Use a ratchet and a 14mm socket to unscrew the banjo screw connecting the hose to the caliper.
Step 9: Place a container under the caliper to catch leaking brake fluid.
Step 10: Use a 13mm pipe spanner to unscrew the metal hose connection from the brake hose.
Step 11: Use a flathead screwdriver to remove the brake hose retaining clip.
Step 12: Unclip the vacuum lines from the brake hose retainer.
Step 13: Remove the old hose and take the new brake hose. Insert it from the upper part.
Step 14: Secure the new hose with the provided clip.
Step 15: Hand-screw the metal hose connection back onto the hose, then finish tightening with the pipe spanner.
Step 16: Use new copper gaskets and the banjo screw on the hose. Install them on the hose.
Step 17: Screw the banjo screw connecting the brake hose to the caliper back in.
Step 18: Use a torque wrench to completely tighten the fastener.
Step 19: Reclip the vacuum lines to the brake hose bracket.
Step 20: Screw the brake hose mounting bracket back on.
Step 21: Replace the ABS sensor cable in its slot.
Step 22: Bleed the brake fluid system to remove air.
Step 23: Put the wheels back on your vehicle.
Step 24: Lower the vehicle and properly block the wheels.
Step 25: Screw the brake fluid cap back on before starting the car.
The operation and tools displayed in the video should be available on the following vehicles :
When replacing a brake hose, you need to bleed the brake fluid system to remove air from the system.
Don’t forget to screw the brake fluid cap back on before starting the car.
Disclaimer:
This video is for entertainment purposes only. CarParts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.