Watch this video to learn how to replace battery on a 2009-2014 Ford F-150.
Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.
There are no tightening torques for this operation.
Here’s the toolbox we recommend to repair your Ford F-150: HM85 85 Piece Ratchet and Socket Set
List of tools:
Step 1: Turn off your engine and engage the parking brake.
Step 2: Pull the hood release handle and open the hood.
Step 3: Locate the battery positioned to the left of the engine compartment.
Step 4: Unscrew the battery clamp to remove the battery.
Step 5: Use a ratchet, an extender, and an 8mm socket to fully unscrew the holding screw of the battery clamp. Remove the battery clamp.
Important Note: Start by removing the negative terminal to prevent sparks and potential damage to the car’s electrical system.
Step 6: With an 8mm wrench, remove the negative terminal from the battery.
Step 7: After removing the terminal, ensure the cable is positioned away to prevent accidental reconnections that could harm the vehicle’s electrical system.
Step 8: Remove the rubber protection from the positive terminal.
Step 9: Repeat the previous step on the positive terminal.
Step 10: Carefully take out the old battery.
Step 11: Use sandpaper to sand the inside of the terminals, removing white oxidation to prevent future electrical issues.
Step 12: Apply copper grease to the terminals to enhance contact and reduce oxidation.
Step 13: Place the new battery in its designated spot and ensure it’s securely in its frame.
Step 14: Start by reconnecting the positive terminal.
Step 15: Secure the terminal in place using an 8mm wrench. Replace the rubber protection.
Step 16: Reconnect the negative terminal. Insert it fully and secure it using the wrench.
Step 17: Put the battery clamp back and tighten it fully using the ratchet.
The operation and tools displayed in the video should be available on the following vehicles :
Always remove the (black) negative terminal (“ground”) first.
When reinstalling the battery, always put the positive (red) terminal back in first.
Once the terminal has been removed, ensure you distance the cable to avoid untimely reconnections which could damage the electrical network of the vehicle.
Disclaimer:
This video is for entertainment purposes only. CarParts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.