The average lifespan of car batteries is around three to five years, but they can deteriorate much faster than that, causing your vehicle to crank slowly or refuse to start completely.
A battery is like an electrical gas tank that holds cold cranking amps. It comes new with a full capacity but diminishes over time to the point that it has too few cold cranking amps to spin the starter and operate the fuel system at the same time.
When a battery fails, the obvious solution is to replace it, but it isn’t always that simple. Sometimes, replacing your car battery can cause more problems.
Here are some examples of common electrical issues that might occur after replacing your car battery:
One of the most common issues that can pop up after a battery replacement is your car refusing to start. In most cases, this usually happens due to improper installation. Turn off your ignition, and check the terminals and wires to make sure everything’s in order.
When it comes to cars, a burning smell is never a good sign. As soon as you catch a whiff of anything burning, it’s a good idea to locate the source as soon as possible.
Think back to when you replaced your car battery. Did you see any sparks after connecting the terminals? Reversed polarity can cause the fuses to blow, damage the alternator, or burn the wiring.
A number of issues can trigger your check engine light, including replacing your car battery. Sometimes, if your vehicle’s computer systems are shut off for too long, they can cause your check engine light and other malfunction indicator lights to turn on.
The idle air control function of the engine control computer has an adaptive learning element so that as the throttle body and its air passages become somewhat clogged by oil steam from the PCV system, the system applies more idle air or throttle to meet the idle target.
When the battery is disconnected, the idle air adaptive learning is lost and returns to the initial programming. In some cases, the vehicle may idle too low or not at all after battery replacement. Again, this doesn’t happen on every vehicle, but it does seem to be more of a problem on ‘90s and early 2000s Dodge pickups.
Pro Tip: It’s a good idea to clean the throttle body when replacing the battery, but even if the cleaning isn’t done, the IAC adaptive strategy will relearn the necessary numbers to get the vehicle to idle again.
In some cases, if the engine has been running with a stuck open thermostat so that extended cold enrichment operation has contaminated the engine oil with fuel mist blowby from the cylinder, and then the oil is changed but the battery isn’t disconnected, rough idle and stalling may be an issue.
Are your power windows suddenly operating erratically after replacing your car’s battery? Replacing your vehicle’s battery typically resets the body control module (BCM), which won’t restart on its own.
In order for your power windows, memory seats, and other power accessories to start working like normal again, you first have to reprogram your BCM manually using a factory scan tool.
Some vehicles have an alarm system that goes off when disconnecting and reconnecting the battery. You can typically disarm the alarm using your car keys, so this shouldn’t be too much of an issue.
One of the most common reasons why people replace their old batteries is because they start to drain faster than usual. Unfortunately, a new car battery won’t always resolve this issue, as a defective alternator, corroded battery terminals, and parasitic drain can all cause your new battery to drain faster than it should.
Wondering what to do after replacing your car battery? Here are some ways you can troubleshoot your car’s electrical problems:
Does your new battery have sufficient voltage? If it isn’t fully charged, it can prevent your vehicle from starting and cause other electrical issues. Conduct a battery test using a multimeter, which should read 12.6 volts for a fully charged battery.
How are your fuses and relays looking? Is the positive cable connected to the positive terminal and the negative cable connected to the negative terminal? Accidentally switching the cables is a recipe for disaster, such as a damaged alternator or burnt wiring.
If your check engine light is on, you can use a scan tool to read for diagnostic trouble codes (DTC). This should help you figure out if it’s really your battery triggering your check engine light or not.
If you think your new battery is draining faster than usual, you can try checking for a draw. Turn off all your car’s electronic systems, and then set up your multimeter.
It’s normal for most cars to experience some draw even with all their electronics turned off, but a reading above 100 milliamps isn’t a good sign.
Nobody likes dealing with electrical problems after replacing their car battery, which is why it’s always a good idea to be extra careful. Here are some tips on how you can safely replace your car battery:
If you’re planning to replace your car battery yourself, be sure to wear insulated gloves and safety goggles. Batteries can explode and you can never be too safe.
Now that you’re aware of the potential problems that could arise when installing a new battery, it’s time to look for a compatible one for your vehicle. Luckily, CarParts.com has an extensive selection of batteries at varying price points.
Shopping for compatible car batteries is made easier thanks to our user-friendly website. Everything is one click away, and you can even browse our catalog from your mobile devices.
Use our vehicle selector to check which products are compatible with your vehicle. Simply select your car’s year, make, and model from the tool to check out which batteries you can choose from.
If you have more questions before completing your order, you can give us a call. Our team is available 24/7 to answer your queries via our toll-free hotline.
Shop our best deals, and get your new battery in as little as two business days.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.