Shop Parts keyboard_double_arrow_right
Need car parts? Select your vehicle
Reading Time: 7 minutes
Summary
  • A bad transfer case will cause gear shifting issues. You’ll also have difficulty staying in 4WD.
  • A puddle might form below where the transfer case is located. It may also produce a grinding, growling, or humming noise.
  • A transfer case will fail as a result of low fluid level (caused by leaks), a lack of maintenance, or normal wear and tear.

The transfer case is one of the most important components that distinguish all-wheel drive (AWD) and four-wheel drive (4WD) vehicles. Driving all four wheels provides superior traction, resulting in improved performance in challenging terrain. This is made possible by the transfer case, which allows power to be transferred to both the front and rear wheels.

When you have a faulty transfer case, you’ll find that you may have difficulty or are unable to switch to AWD or 4WD.

In this article, we’ll discuss some of the symptoms you may experience when this component fails.

car transfer case
The transfer case allows power to be transferred to both the front and rear wheels.

What are the Symptoms of a Bad Transfer Case?

The transfer case is supposed to last the life of the vehicle—but that doesn’t always happen. Here are some of the most common signs you may encounter when you have a bad transfer case:

Gear Shifting Issues

One symptom of a bad transfer case is when you have trouble shifting between gear ranges. Although the issue can be caused by something simple, such as a low fluid level or damaged linkage, it typically indicates an internal transfer case failure.

Before assuming something is wrong, however, make sure that you’re following the directions (in your owner’s manual) for operating the transfer case. In many instances, before shifting into four-low, the vehicle must be stopped and the transmission placed into neutral.

Otherwise, you’ll hear a grinding noise when trying to shift gears.

Note that while some transfer cases are controlled by the body computer, transfer cases on most modern vehicles are electrically-switched. As such, some vehicles may exhibit different symptoms.

Difficulty Staying in 4WD

Another common problem is a transfer case that pops out of 4WD. The issue can be attributed to outside influences (e.g., a problem with the differential or driveshaft) or it might be due to an internal transfer case concern.

See also  P0837 Code: Four-Wheel Drive (4WD) Switch Circuit Range/Performance

4WD Will Not Engage/Disengage

There are many reasons why a vehicle’s 4WD system won’t engage or disengage. The issue could be due to anything from a faulty shift mechanism on the front axle to an electrical fault in the control system.

It’s also possible that the transfer case has internal problems.

Puddle Formation Directly Under the Transfer Case’s Location

There’s only one reason why there’s a greasy puddle building up underneath your car—there has to be a leak somewhere.

And that somewhere could be the transfer case.

Verify that the leak is coming from the transfer case by jacking up your car and visually inspecting it. You should easily see it at the rear-end part of the transmission or transaxle assembly.

If a leak is gradual (and they often are), you may not see a puddle, but over a period of time, the transfer case can become dangerously low on oil, leading to the destruction of internal components. This takes longer than a manual transmission to show up because transfer cases have an oil pump—manual transmissions typically don’t.

Weird Grinding, Growling or Humming Noises

Another telltale sign of a problem in your car is the presence of weird noises that weren’t there before. Abnormal noises can be bothersome, and they almost always indicate that bigger problems are right around the corner.

If you hear a grinding, growling, or humming noise that changes with vehicle speed, it might be coming from the transfer case. The root cause could be low fluid level or a mechanical problem, such as a loose chain, bad bearings, or damaged gears.

, Bad Transfer Case Symptoms

Pro Tips are nuggets of information direct from ASE-certified automobile technicians working with CarParts.com, which may include unique, personal insights based on their years of experience working in the automotive industry. These can help you make more informed decisions about your car.

Pro Tip: On many transfer cases, a loose chain will rub a hole in the top of the transfer case housing, thus there are rebuild kits that include a new chain and the front half of the case. Replacing the chain and the front case half should, however, be done by a professional rather than a DIY person.

4WD Warning Light Illuminates

Some vehicles have a “service four-wheel-drive” message (or something similar) that pops up on the dash when there’s a problem in the system. Other vehicles will simply keep the 4WD light illuminated continuously to indicate a problem, which could be a bad transfer case.

What are the Possible Causes of a Bad Transfer Case?

Typically, a transfer case will fail due to a low fluid level (caused by leaks), lack of maintenance, or regular wear from use.

It’s important to address fluid leaks right away (as soon as you discover one) to prevent internal transfer case damage. Changing the transfer case fluid on a regular basis is also important. You can find the service interval for your vehicle’s transfer case in the owner’s manual.

See also  A Crash Course on 4WD Systems

Bad Transfer Case or Transmission Problem?

The transfer case is a part of your vehicle’s drivetrain, as is the transmission—and they both have their respective functions. Despite this, the symptoms of transmission failure can mimic those of a bad transfer case. This can sometimes result in confusion for vehicle owners who are attempting to fix their car themselves.

To avoid any confusion, it’s a good idea to have a professional diagnose your vehicle if you suspect a transfer case problem, as they would have the proper tools (and years of experience) to better assess your vehicle and its underlying issues.

Note that bad four-wheel-drive locking hubs can be construed as a transfer case problem as well and can, if they fail engaged, damage the front differential.

As an interesting side note, some older transfer case systems, such as on early 90s Fords, will, when they illuminate the “Low Range” indicator, cause the Powertrain Control Module to use a different shift schedule, causing it to shift through all its gears at very low speeds. The point is that something as simple as a blown fuse (killing power to the Low Range light) can cause this issue.

Some older transfer case systems, such as on early 90s Fords, will, when they illuminate the “Low Range” indicator, cause the Powertrain Control Module to use a different shift schedule, causing it to shift through all its gears at very low speeds.

Richard McCuistian, ASE Certified Master Automobile Technician
mechanic doing maintenance check under the car
It’s best to have a professional mechanic check your vehicle because the symptoms of a bad transfer case and transmission failure can be similar.

Can Bad Transfer Case Damage the Transmission?

There are instances where a catastrophic transfer case failure can damage other parts of your vehicle, including the transmission. It’s always a good idea to address any known issues with your vehicle as soon as possible to avoid additional problems.

Some Ford Trucks had issues with their electronic modules that would randomly put the vehicle in four wheel drive at highway speed, causing tremendous destruction. There was a dealer program concerning this, so check your VIN at the Ford dealer to see if your vehicle is at risk.

What is a Transfer Case?

As previously mentioned, the transfer case is found on vehicles with AWD or 4WD capability and is integral in allowing drivers to switch to these modes of operation.

4WD Transfer Case

A typical 4WD transfer case is found at the rear of the transmission. It is powered by the transmission output shaft and operates much like a secondary transmission.

Most 4WD transfer cases have four modes of operation: two-high, neutral, four-low, and four-high. Because the driver only engages the 4WD when needed, this type of system is called “part-time” four-wheel drive.

See also  What Does Service 4WD Mean? Triggers, How to Clear, and More

The desired gear range may be engaged with a lever, engine vacuum, or onboard electronics.

AWD Transfer Case

AWD systems distribute power to all four wheels without any driver input. Many modern SUVs have AWD and a front-wheel drive-bias layout. Vehicles with this design have a transaxle instead of a transmission.

The transfer case mounts to the side of the transaxle and distributes power to the rear differential and one of the front CV axles. You may also hear people refer to this type of transfer case as a power transfer unit (PTU) or something similar.

These systems have what is called a “viscous coupling” in the system. Without it, full time four wheel drive wouldn’t be possible.

Think of how part time four-wheel drive requires all four tires to be exactly the same size and how the part time system will experience “driveline windup” if operated on a flat, dry surface with the four wheel drive engaged.

There are also some vehicles that have AWD and a rear-wheel drive-bias layout. With this design, the transfer case is much like one found in a 4WD vehicle. The primary difference is that the transfer case doesn’t have multiple gear ranges for the driver to choose from (operation is automatic).

That’s why this type of setup is sometimes referred to as full-time 4WD.

There are also electronically activated automatic four wheel drive systems that only engage when needed and cannot be controlled by the driver.

Where to Get a New Transfer Case for Your Vehicle

Driving around with a bad transfer case is a disaster waiting to happen. The transfer case plays a crucial role in your vehicle’s drivetrain system, and if it fails, it won’t be long before issues arise in your vehicle’s overall performance. This can make driving dangerous, so don’t put off replacing it. Fortunately, getting a new transfer case is a breeze with CarParts.com.

Use our vehicle selector to view replacement transfer cases that are compatible with your vehicle. Enjoy fast and reliable shipping, thanks to our on-hand products and strategically located warehouses across the US. Place your order today, and we’ll have it delivered to your doorstep in as fast as two business days.

Don’t wait for the worst-case scenario to unfold before replacing your faulty transfer case. Shop for a new transfer case from CarParts.com today.

Products Mentioned in this Guide

About The Authors
Written By Automotive and Tech Writers

The CarParts.com Research Team is composed of experienced automotive and tech writers working with (ASE)-certified automobile technicians and automotive journalists to bring up-to-date, helpful information to car owners in the US. Guided by CarParts.com's thorough editorial process, our team strives to produce guides and resources DIYers and casual car owners can trust.

Reviewed By Technical Reviewer at CarParts.com

Richard McCuistian has worked for nearly 50 years in the automotive field as a professional technician, an instructor, and a freelance automotive writer for Motor Age, ACtion magazine, Power Stroke Registry, and others. Richard is ASE certified for more than 30 years in 10 categories, including L1 Advanced Engine Performance and Light Vehicle Diesel.

Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.

File Under : DIY , Drivetrain Tagged With :
Curt Cargo Carrier Rebate
Subscribe
Notify of
guest
96 Comments
Inline Feedbacks
View all comments
Mackesha Sue Lewis

I have a 2013 jeep grand cherokee, and when i am stopped at a red light and go to take off when the light turns green i hear a thump like something popped out of place in the back of the jeep, i have been told by a mechanic that it could either be the transfer case or tansmission but they was not 100% sure which one it was. What are your thoughts?

CarParts.com

Hello,

The first thing I would check is the u-joints. A worn-out u-joint (which is a lot less expensive than a replacement engine or transmission) can easily cause a clunk upon acceleration.

Caleb

I have a 2005 Ford F150 lariat with 117k miles. I had the transmission out at 110k as the 3rd gear clutch pack was completely burnt out. Replaced a bunch of parts, installed a shift kit in the valve body, lower rpm torque converter and I was good to go. All was working perfectly up until now. When I drive, I often manually shift into 2nd to let the engine slow me down some coming to stops or corners. When I did this yesterday, something broke and caused the engine to stop turning. Rolled to a stop and the engine starts and runs fine, but I now have zero gears whatsoever. Park doesn’t work, no forward or reverse gears, nothing. There is a grinding when I try to put it in Park. When I towed it home, I had to drop the driveshaft because I was getting even worse noises when moving. Any thoughts?

CarParts.com

Hi Caleb,

While it’s possible the transfercase is to blame, the transmission is a far more likely culprit. Something may not have been put together properly during the rebuild. Of course, for a definitive answer, you’ll need to visit a professional in your area for an in-person assessment (or do some troubleshooting on your own).

Also, you might not want to use that engine-braking strategy on a regular basis. Automatic transmissions aren’t designed for such use, and you could end up doing more harm than good.

ryan dzwlewicz

I have a 2008 jeep wrangler I went to take it on the beach and at times I would press on the gas but the tires did not move. Drives fine on the road and i don’t hear any weird noises.

CarParts.com

Hi Ryan,

Is the vehicle essentially in neutral or is the four-wheel drive just not engaging?

Brenda

I have a 2002 Hyundai Sante Fe just had the cv axles and transfer case changed last week at the repair shop. Picked the car up from the shop Fri, put car in reverse it had a rough idle but it was almost empty of gas. Put in fuel and it smoothed out. Have driven the car less than 50 miles since I got it out of shop and the power steering reservoir is now leaking and the car has a bad misfire and not shifting gears correctly Car had no problems with misfire or rough idling or shifting problems until change out.

CarParts.com

Hi Brenda,

The shop would have had to disconnect some sensors while replacing the transfer case, so it’s possible the issues you’re now experiencing are related to the repair. It’s also possible that it’s just an unfortunate coincidence. I would contact the shop and ask them to take a look.

Larry McConnell

I have a 2014 gmc sierra. And my truck just all of a sudden got stuck in 4×4. I had to pull the TREC 4×4 fuse to put transfer case module to sleep to disengage my 4wd. Is that a bad transfer case module doing that?

CarParts.com

Hi Larry,

I’m assuming your transfer case has the shift lever on the floor instead of the dial on the dashboard?

expand_more
CarParts.com Answers BE PART OF OUR COMMUNITY: Share your knowledge & help fellow drivers Join Now
The owner of this website has made a commitment to accessibility and inclusion, please report any problems that you encounter using the contact form on this website. This site uses the WP ADA Compliance Check plugin to enhance accessibility.